Creep Studies in Aluminium-2.25WT.% Magnesium.
Loading...
Date
1985
Authors
Journal Title
Journal ISSN
Volume Title
Publisher
Obafemi Awolowo University
Abstract
In this project, a study of creep mechanism in an Al-2.25wt% Mg alloy is conducted at temperatures between 573K and 623K and stresses (α ) ranging from 7.70 to 48.10 Mpa. Using the dislocation network model, the characteristics features of recovery-controlled and glide-controlled creep mechanisms are delineated. One of the manifestations of the fundamental differences between these two mechanisms, it is demonstrated, is the disparity which should be observed between the experimentally observed obstacle strength parameter α exp in the equation
σ =α exp Gb/p
where G, b and p are the shear modulus, the Burgers vector of dislocations and the dislocation density respectively and the theoretically calculated value, αo. Specifically, the theoretical model predicts that α exp for glide creep should be greater than α exp for recovery creep.
The conditions under which a transition from one creep mechanism to the other could occur in a given material are investigated (theoretically). It is demonstrated that for creep to be glide-controlled, the dislocation glide velocity Vg must be related to the annihilation rate p a according to the expression Vg << β pa / (α1p3/2),
where α1 and β are constants. Otherwise, creep should be recovery-controlled. The implications of the theoretical model on the shape of creep curves for both mechanisms are discussed and are shown to be generally consistent with literature data.
The creep tests performed on the Al-Mg alloy show that inverse transient creep curves are observed at low stresses and normal transients at high stresses. Also a change in transient creep curve shapes are observes when the annealed samples are restrained prior to creep. Stress increase and stress removal tests performed (in the high stress range) during creep reveal certain creep characteristics which are trademarks of recovery-controlled creep at high stresses. Recovery tests performed on restrained samples show that the flow stress decreases with recovery time, even though it never quite approaches the value characteristics of annealed samples.
Description
Keywords
Creep mechanism
Citation
APA