Theses and Dissertations

Permanent URI for this collection

https://ir.oauife.edu.ng/handle/123456789/804
Theses and Dissertations ( Metallurgy and Materials Enginering)

Browse

Browsing Theses and Dissertations by Author "Adewoye, O. O."

Now showing 1 - 2 of 2
  • Thumbnail Image
    Item
    Open Access
    Effect of Composition on the Dielectric Properties of Electrical Porcelain.
    (Obafemi Awolowo University, 1987) Akinbami, John-Fekix Kayode; Adewoye, O. O.
    The effect of compositional change on the dielectric properties (i.e. dielectric constant, dielectric resistance, dissipation factor, loss factor) of Electrical Porcelain has been investigated. The evaluation was carried out using six different compositions. The capacitance and resistance of the samples of the six different compositions over a frequency range of 10 to 105 Hertz were measured. From these experimentally obtained values of resistance and capacitance, the values of the dielectric properties mentioned above were calculated. The samples of the six different compositions were compacted under four different compaction pressures: 2.2 x 108 N/m2, 3.0 x 108 N/m2, 3.2 x 108 N/m2 and 3.5 x 108 N/m2, and fired at four different temperatures: 1250°C, 1300°C, 1350°C and 14000C, and the samples were of varying thicknesses ranging from 2.5mm to 8mm. Available information from the present work suggest that sample “C” with composition, Kaolin, 39.25%; Feldspar, 24.50%; and Quartz, 36.25% gives the best dielectric properties of all the six different compositions. The most probable firing temperature, so as to avoid over firing as well as allow for dense formation to give good dielectric properties of the wares produced, is 1350°C.
  • Thumbnail Image
    Item
    Open Access
    Effects of Microstructures on the Thermal Properties of Refractory Materials.
    (Obafemi Awolowo University, 1986) Adeoye, Mosobalaje Oyebamiji; Adewoye, O. O.
    The factors controlling the thermal properties of refractory clays obtained from Omi-Adio were investigated. Methods of controlling these factors in refractory bricks were also looked into. A complete feasible step in making of typical refractory bricks out of these clays was suggested, taking note of critical parameters like water content, particle size, compaction pressure and firing temperatures involved. It was found that porosity and pore size played major roles in controlling the thermal properties of the refractories obtained from the clays. Strengths after firing at various temperatures were noted too, including source and mode of failure. The suitability of the bricks as structural materials in terms of strength, and as decorating materials in terms of colour, was found to be good.